Up to 3 Sessions of Body Cryolipolysis in the Beauty Salon «Body Like»

Cryolipolysis Thermal Shock System 360° with 4 maniples is the latest generation cryolipolysis, 2022 for hardware cryoliposuction - fat freezing (reduction of local deposits).

The results you will get after the procedure:

• Weight correction.
• Elimination of stress kilograms.
• Improve body contour.
• Powerful lymphatic drainage.
• Recovery after childbirth.
• Preparing a figure for a responsible event in a short time.

Getting rid of local fat deposits in the area:

• Inner and outer thighs - riding breeches.
• Zones under the buttocks and buttocks.
• Areas above the knees.
• Lower legs.
• Lower and upper abdomen.
• Sides.
• Pleats on the back.
• The inside of the hands.
• Second chin.

With cryolipolysis, the process of apoptosis occurs - the programmed death of fat cells. During the procedure, the fat cell, after freezing, breaks down into fatty amino acids and water. Water is excreted naturally, and fatty amino acids are excreted through the work of internal organs.

Advantages of the Thermal Shock System 360°:

• The cryolipolysis procedure can be carried out simultaneously with four maniples of maximum diameter.
• The maniples do not have two cooling plates, as on the devices of the old generation, but a full diameter of 360° degrees of cooling surface - for each maniple, three sizes of silicone pads are offered, of different curvature, length and width, for different curves of the figure.
• Maximum weight loss up to - 12 centimeters in diameter.
• Reduced procedure time, as 2, 3 or 4 maniples are used at once. Now you only need one hour instead of 4 hours to remove 12 cm in diameter.
• Saving time and money.
• Convenient comfortable procedure.
• New thermal shock system, increase in the speed of the result.
• Painless procedure and pleasant recovery of the cooled area by gradual warming up.

How it works?

• Training. Measurement of the fat layer with a gyrometer, selection of the number and size of maniples, selection of silicone pads, according to the individual curves of the body, application of freon membranes to the treatment area.
• Preheating. Maniples through freon membranes draw in the fat layer with the help of vacuum. The zone is heated from 42 ℃ to 45 ℃.
• Cooling. Thermal shock effect caused by the rapid transition from heat to cold on the treated fabric. The processed fat layer is optimally cooled from -2° to -7°.
• Relaxation procedure - heating. At the final stage - warming up, there is a rapid transition from cold to heat. This is done to improve blood circulation and stimulate metabolism and relaxation at the end of the procedure.
• Apoptosis process. The crystallized fat cells then undergo apoptosis and are naturally eliminated from the body through metabolic processes.
• After the procedure, there is a significant reduction in adipose tissue in the treated area.

Contraindications:

• Violation of sensitivity. Patients cannot tell when they become numb from cold. Tissue damage can occur at temperatures slightly below those that cause numbness.
• Impaired circulation. Tissue damage can occur as a result of vasoconstriction.
• Surgical or other open wounds less than 14 days old.
• Hypersensitivity to cold, such as Raynaud's syndrome, cold urticaria, cryoglobulinemia, and paroxysmal cold hemoglobinuria.
• Angina pectoris or any heart disease.
• Degeneration of peripheral nerves.
• Arteriosclerosis.
• Phlebeurysm.
• Diabetes.
• Anemia.
• Chills.
• Skin diseases (rash or open wounds).
• Oncological diseases.